I've got the usual 1/2 HP Craftsman Garage Door Opener. I've looked at all the messages on this forum and most seem to involve the sensor light and partial operations. However I have the following issue. When using the wall panel switch, everything works no problem.
Using the remote only causes the motor units light to blink for maybe 10 times. There is also a small green light on the wall swithch that appears to be blinking, but it's so fast I'm not sure that it's blinking, and I'm not sure that it isn't always like this and I just haven't noticed. If anyone has any idea, please let me know.
Craftsman garage door opener (1/2 hp) - light flashing most of the time when the lights start flashing on them and they won't work it's something in the way of the eyes that cross the garage at the bottom are something bummed them and there not lining up no more check that first. Jan 02, 2017 My Craftsman 1/2 hp gar. Driver Da Impressora Epson Tx105 Para Windows 7. Opener has a red reset button on it on the l/h side as you are looking at the light/motor from the garage door opening. You have to take the light cover off to.
Thanks, Jeff. Hey guys, My Garage Door Opener(Craftsman 1/2 HP) only closes the door halfway, then bounces back. Download Free Sins Of The Solar Empire Patch Fr Software Canon on this page. I pulled the trigger to manual, closed and opened door completely by hand once to make sure nothing block the rail track,also nothing blocking the door way, then switched back to auto, pressed the wall switch, it worked fine at the first try(closed and opened door successfully), but it closed half way and bounced back again at the second and third try, then stay that way. I noticed the light blinks few(2-3) times every 10 seconds on the opener box, I got same testing result no matter pressing on wall switch or remote. Is this have something to do with the sensor? Please advise, thanks!
It's tough when there's a power surge or a lightning storm because you never know if the main logic board got damaged. This might be the case with the light that won't turn off. As far as door #2 the down limit needs to adjusted. The trolley is going too far down and after the door is fully closed the force goes into the track and makes it bow upward. The limits are on the side of the opener. Adjust by ~1/4 turn. Note the change.
Healthpointe 2 0 Program Ma there. Repeat this as needed until, under a normal cycle, the trolley stops when the door is closed. Hope that helps.
You will want to erase all codes from the opener so that the remote that was stolen will no longer work on your opener. Pushing and holding the learn button on the logic board for 10 seconds will erase all codes from the opener.